Wednesday, September 8, 2010

Kawasaki ZX6r 2010

Tape fairing over with masking Replace the fairing and mark the edge of the fairing that needs modification. Tighten the frame slider to the manufacturer's recommended torque settings. Install the provided right frame slider ( Shorter Aluminum spacer ) and 130mm bolt and re-use nut.

Remove( See picture ) correct engine bolt and save the nut. Included in this frame slider kit: (1) 10mmX90mm 1.25 pitch bolt (left) (1) 10mmX130mm 1.25 pitch bolt (right) (2) Aluminum bushings (pressed into slider) (2) Plastic Frame Sliders (left -longer, right-shorter) INSTRUCTIONS: Left Hand Side ( Sitting On Bike ) Remove left side fairing. Some fairing modification is required on the left side. It is highly recommended that you refer to your service manual before performing this installation. This kit has separate left and right pieces (left and right while sitting on the bike).

These frame sliders are designed to fit specific engine mounts of your 2005 Kawasaki ZX6R 636 Ninja. Please read all instructions before beginning work! Sportsriders around the world who have tested various models of our products on the track have all given their thumbs up after experiencing first hand, the benefits of Motovation Frame Sliders. They are tough but not brittle and can also absorb a huge impact. Each and every model is tested for drop and slide protection.

Motovation frame sliders are designed and manufactured by a company that only makes frame sliders.  These sliders have been designed to offer unsurpassed protection to your 2005 Kawasaki ZX6R 636 Ninja in the unfortunate event of a lowside or tip over.

No comments:

Post a Comment